PR=Starts and Deletes old Programs.  Deletes only if their is more then one then one program in emulator

NE=Deletes a Single Program in Emulator (most common one used)

PA=Brings you to your Program editor so you can start typing code.  (Note the first time you come in after starting a new program you will need to renumber your lines)

SD,2=This code saves your Program to the Computer or Memory stick as you choose (same thing as hitting File Save As in most Software) Once into this mode you need to pick your drive you  wish to save in(for a Hard drive it is usually drive C.  For a Memory stick it is usually drive E or F) you then must Name your Program by hitting the Type Button.  You can use no more then 7 letters followed by a .NC Once your done naming it move your mouse on the name and Click the Name.  Your Program is now saved.

RD=This code is used to bring up a Program saved on a Memory stick or hard drive(same thing as hitting File Open in most software) This screen looks the same as the saved screen and the steps are almost the same.  Click the Drive you want and then click the name of the part in the drive.  Then move up to the top Right hand Corner and Click the name again.  It will bring you back to command mode. Now your program has been brought back up.

RI=Deletes everything in emulators Memory (don't use unless your know that is what you want.  Very important on Machine)

DR=Brings you to graphics menu (can also be done in PA mode by hitting G)

DT-This is your Tool Table where you put all your info on your tools (IE the tool Diameters and Length Offsets)
 

 Created By Jeff Burns
 03/06/08
 San Diego City College
 Machine Technology